HEIDENHAIN TNC 407 (280 580) ISO Programming - Manual (Page 89)

TNC 426/TNC 425/TNC 415 B/TNC 407 3-3
3 Test Run and Program Run
3.1 Test Run
ENT e.g. 5
1 2 3
ENT e.g.
ENT
1 e.g.
or
To run a program test up to a certain block:
With the STOP AT N function the TNC does a test run up to the block
with block number N.
Select the TEST RUN mode and go to the program beginning.
Select a partial test run.
STOP AT: N =
PROGRAM =
REPETITIONS =
Enter the block number N at which you want the test to stop.
Enter the name of the program that contains block number N.
If N is located in a program section repeat, enter the number of
repeats that you want to run.
Test the program up to the entered block.
The display functions for test run
In the TEST RUN operating mode the TNC offers functions for displaying a
program in pages.
Shift the soft-key row.
Function Soft key
Go back in the program by one screen
Go forward in the program by one screen
Go to the beginning of the program
Go to the end of the program