HEIDENHAIN TNC 407 (280 580) ISO Programming - Manual (Page 125)

TNC 426/TNC 425/TNC 415 B/TNC 407 4 - 2 8
4 Programming
/
X
4.9 Marking Blocks for Optional Block Skip
You can mark program blocks so that the TNC will skip them during
a program or test run whenever the block skip option is active (see
page 3-10).
To mark a block:
Select the desired block.
Mark the beginning of the block with a slash.
• Blocks containing a tool definition (G99) cannot be skipped.
• To skip cycles, program the slash in the first block of the cycle.
To erase the slash:
Select the block that contains the slash to be erased.
Erase the slash at the beginning of the block.