HEIDENHAIN TNC 407 (280 580) ISO Programming - Manual (Page 311)

11-14
11 Tables, Overviews and Diagrams
TNC 426/TNC 425/TNC 415 B/TNC 407
Machining and program run
11.1 General User Parameters
Corners whose angles are less than the entered value will be machined at a decelerated feed rate (if radius compensation
is R0 or if the angle is at an inside corner)
This feature works both during operation with servo lag as well as with feed precontrol.
MP7460 0.0000 to 179.9999 [°]
Maximum contouring speed at a feed rate override setting of 100% in the program run modes
MP7470 0 to 99 999 [mm/min]
Datums from a datum table are referenced to the
MP7475 Workpiece datum: 0
Machine datum: 1 1 1 1 1
425 415 407