beautypg.com

Measuring angles -22 – HEIDENHAIN TNC 407 (280 580) ISO Programming User Manual

Page 83

background image

TNC 426/TNC 425/TNC 415 B/TNC 407

2 - 2 2

2

Manual Operation and Setup

2.6

Measuring with a 3D Touch Probe

.

.

.

END

I

.

.

.

or

X + X – Y + Y – Z + Z –

Select the probe direction with the cursor keys – same axis as for

1.

Probe the workpiece.

The value displayed as DATUM is the distance between the two points.

To return to the datum that was active before the length measurement:

Select the probing function with the soft key PROBING POS.

Probe the first touch point again.

Set the DATUM to the value that you wrote down previously.

Terminate the dialog.

Measuring angles

You can also use the touch probe to measure angles in the working plane.
You can measure

• the angle between the angle reference axis and a workpiece side, or
• the angle between two sides.

The measured angle is displayed as a value of maximum 90°.

To find the angle between the angle reference axis and a side of the workpiece:

Select the probing function with the soft key PROBING ROT.

ROTATION ANGLE

If you will need the current basic rotation later, write down the value that appears under ROTATION ANGLE.

Make a basic rotation with the side of the workpiece (see section “Compensating workpiece misalignment”).