HEIDENHAIN TNC 407 (280 580) ISO Programming - Manual (Page 290)

1 0 - 3
10 MOD Functions
TNC 426/TNC 425/TNC 415 B/TNC 407
MOD
ENT
5 e.g.
END
or
ENT
Repeatedly
If necessary
10.1 Selecting, Changing and Exiting the MOD Functions
To select the MOD functions:
Change to the desired mode of operation.
Select MOD functions.
To change the MOD functions:
Use the arrow keys to move the highlight to the desired MOD function.
Page through the MOD functions until you find the desired function.
Enter the appropriate numbers and confirm entry with ENT.
To exit the MOD functions:
Close the MOD functions.
10.2 Software Numbers and Option Numbers
The software numbers of the NC and PLC are displayed in the MOD
function opening screen. Directly below them are the code numbers for
the installed options (only for conversational programming).
• Digitizing option OPT: 1
• Digitizing and measuring touch probe options OPT: 11
10.3 Code Numbers
A code number is required for access to certain functions:
Function Code number
To cancel file erase and 86 357
edit protection (status P)
To select user parameters 123