beautypg.com

Pocket table for tool changer -14 – HEIDENHAIN TNC 407 (280 580) ISO Programming User Manual

Page 111

background image

TNC 426/TNC 425/TNC 415 B/TNC 407

4 - 1 4

4

Programming

4.2

Tools

Fig. 4.6:

Pocket table for the tool changer

Overview: Information in pocket tables

Pocket table for tool changer

The TOOL_P table (for tool pocket) is programmed
in a program run operating mode.

The soft key NEW POCKET TABLE (or RESET
POCKET TABLE) is for erasing an existing pocket
table and writing a new one.

Like the tool table, a pocket table can also be read in
and read out directly through the data interface (see
page 4-11).

To select the pocket table:

Select tool table.

Select pocket table.

Set the EDIT soft key to ON.

To edit the pocket table:

Abbreviation Input

Dialog

P

Pocket number of the tool

T

Tool number

TOOL NUMBER

F

Fixed tool number. The tool is always returned to the
same pocket.

FIXED POCKET
YES = ENT / NO = NOENT

L

Locked pocket

POCKET LOCKED
YES = ENT / NO = NOENT

S T

Special tool with a large radius requiring several pockets
in the tool magazine. If your special tool takes up pockets
in front of and behind its actual pocket, these additional
pockets need to be locked.

SPECIAL TOOL

PLC

Information on this tool pocket that is to be sent to
the PLC

PLC STATUS