HEIDENHAIN TNC 407 (280 580) ISO Programming - Manual (Page 47)

TNC 426/TNC 425/TNC 415 B/TNC 407 1 - 2 9
1 Introduction
Main program name
Coordinates of the datum shift
Angle of basic rotation
Mirrored axis
Scaling datum
(conversational programming only)
Scaling factor(s)
T: Tool name and number
RT: Name and number of a replacement tool
Tool axis
Display of the programmed tool and the (next)
replacement tool
Tool life, maximum tool life and maximum tool life
for TOOL CALL
Oversizes (delta values)
Tool length and radii
Number of the tool to be measured
Measured MIN and MAX values of the
single cutting edges and the result of
measuring the rotating tool
Display whether the tool radius or the tool length is
being measured
Cutting edge number with the corresponding
measured value. If the measured value is
followed by an asterisk, the allowable tolerance
defined in the tool table was exceeded.
Tool information
Tool measurement (only available with conversational programming)
Coordinate transformations
1.4 Graphics and Status Displays