HEIDENHAIN TNC 407 (280 580) ISO Programming - Manual (Page 90)

TNC 426/TNC 425/TNC 415 B/TNC 407
3 Test Run and Program Run
3-4
Only in mode
PROGRAM RUN /
SINGLE BLOCK
for each block
GOTO 0
ENT
I
I
3.2 Program Run
In the PROGRAM RUN / FULL SEQUENCE mode of operation the TNC
executes a part program continuously to its end or up to a program stop.
In the PROGRAM RUN / SINGLE BLOCK mode of operation you must
start each block separately by pressing the machine START BUTTON.
The following functions can be used during a program run:
• Interrupt program run
• Start program run from a certain block
• Blockwise transfer of very long programs from external storage
• Block skip
• Editing and using the tool table TOOL.T
• Checking/changing Q parameters
• Graphic simulation
• Additional status display
To run a part program:
• Clamp the workpiece to the machine table.
• Set the datum.
• Select the necessary tables and pallet files.
PROGRAM RUN / SINGLE BLOCK
or
PROGRAM RUN / FULL SEQUENCE
Select the part program and the necessary tables and pallet files in the file directory.
Go to the first block of the program.
Run the program.
Run each block of the part program separately.
You can adjust the feed rate and spindle speed with the override knobs.