HEIDENHAIN TNC 407 (280 580) ISO Programming - Manual (Page 291)

1 0 - 4
10 MOD Functions
TNC 426/TNC 425/TNC 415 B/TNC 407
• The HEIDENHAIN ME 101 magnetic tape unit (ME mode of operation) can only be used in the TNC mode of
operation PROGRAMMING AND EDITING (not on TNC 426).
The following note applies to the TNC 426:
• The functions “Transfer all files”, “Transfer selected file” and “Transfer directory” are not available in the
operating modes FE2 and EXT.
426
10.4 Setting the External Data Interfaces
Press the soft key marked RS 232- / RS 422 - SETUP to call a menu for
setting the external data interfaces.
• MODE OF OP. – Type of external storage device: FE1, FE2, ME, EXT1,
EXT2, LSV2
• BAUD RATE – Sets the data transfer speed (110 to 38400 baud)
• ASSIGN – Assigns either the RS-232 or the RS-422 interface to the
operating modes
• PRINT – Outputs digitized data through RS-232, RS-422 or FILE
Setting the RS-232 interface
The mode of operation and baud rates for the RS-232 interface are
entered in the upper left of the screen.
Setting the RS-422 interface
The mode of operation and baud rates for the RS-422 interface are
entered in the upper right of the screen.
Selecting the OPERATING MODE
External device OPERATING MODE
HEIDENHAIN floppy disk units
• FE 401 B
FE1
• FE 401 with program no. 230 626 03
or higher
FE1
HEIDENHAIN FE 401 floppy disk unit
with program number below 230 626 02
FE2
PC with HEIDENHAIN data transfer
software TNC. EXE
FE2
HEIDENHAIN ME 101 magnetic tape unit ME
(no longer produced)
Non-HEIDENHAIN devices such as printers,
tape punchers, PCs without TNC. EXE
EXT1, EXT2
PC with HEIDENHAIN software
TNC REMOTE for remote operation
LSV2
Setting the BAUD RATE
On the TNC 425, TNC 415 B and TNC 407 controls, the baud rate (data
transfer speed) can be selected from 110 to 38 400 baud. The baud rate of
the ME 101 is 2400 baud.
On the TNC 426, the baud rate (data transfer speed) can be selected from
110 to 115 200 baud.