HEIDENHAIN TNC 407 (280 580) ISO Programming - Manual (Page 313)

11-16
11 Tables, Overviews and Diagrams
TNC 426/TNC 425/TNC 415 B/TNC 407
11.2 Miscellaneous Functions (M Functions)
Miscellaneous functions with predetermined effect
M Effect Effective at block Page
start end
M00 Stop program run/spindle STOP/coolant OFF • 3-5
M02 Stop program run/spindle STOP/coolant OFF/
Clear status display (depending on machine parameter)/
Go to block 1
• 3-5
M03 Spindle ON clockwise •
M04 Spindle ON counterclockwise •
M05 Spindle STOP •
M06 Tool change/stop program run (depending on machine parameter)/
Spindle STOP
• 3-5
M08 Coolant ON •
M09 Coolant OFF •
M13 Spindle ON clockwise/coolant ON •
M14 Spindle ON counterclockwise/coolant ON •
M30 Same function as M02 • 3-5
M89 Vacant miscellaneous function or •
Cycle call, modally effective (depending on machine parameter) • 8-3
M90 Only in lag mode: Constant contouring speed at corners • 5-36
M91 Within the positioning block: Coordinates are referenced to machine datum • 5-39
M92 Within the positioning block: Coordinates are referenced to position
defined by machine builder, such as tool change position
• 5-39
M93 Reserved •
M94 Reduce display of rotary axis to value less than 360° • 5-43
M95 Reserved •
M96 Reserved •
M97 Machine small contour steps • 5-37
M98 Completely machine open contours • 5-38
M99 Blockwise cycle call • 8-3