beautypg.com

Stop program run/spindle stop/coolant off, Spindle on clockwise, Spindle on counterclockwise – HEIDENHAIN TNC 407 (280 580) ISO Programming User Manual

Page 333: Spindle stop, Coolant on, Coolant off, Spindle on clockwise/coolant on, Spindle on counterclockwise/coolant on, Same function as m02, Vacant miscellaneous function or

background image

Miscellaneous Functions (M Functions)
Miscellaneous Functions with predetermined effect

The miscellaneous functions M105 and M106 are defined and enabled by the machine tool builder.
Please refer to your machine manual for more information.

M Effect Effective at block Page

start end

M00 Program run/spindle STOP/coolant OFF • 3-5

M02 Program run/spindle STOP/coolant OFF/

Clear status display (depending on machine parameter)/
Go to block 1 • 3-5

M03 Spindle ON clockwise •
M04 Spindle ON counterclockwise •
M05 Spindle STOP •

M06 Tool change/stop program run (depending on machine parameter)/

Spindle STOP • 3-5

M08 Coolant ON •
M09 Coolant OFF •

M13 Spindle ON clockwise/coolant ON •
M14 Spindle ON counterclockwise/coolant ON •

M30 Same function as M02 • 3-5

M89 Vacant miscellaneous function or

Cycle call, modally effective (depending on machine parameter) • 8-3

M90 Only in lag mode: Constant contouring speed at corners • 5-36

M91 Within the positioning block: Coordinates are referenced to machine datum • 5-39

M92 Within the positioning block: Coordinates are referenced to position

defined by machine builder, such as tool change position • 5-39

M93 Reserved •

M94 Reduce display of rotary axis to value less than 360° • 5-43

M95 Reserved •

M96 Reserved •

M97 Machine small contour steps • 5-37

M98 Completely machine open contours • 5-38

M99 Blockwise cycle call • 8-3

M101 Automatic tool change with replacement tool if maximum tool life has expired • 4-16
M102 Reset M101 • 4-16

M103 Reduce feed rate during plunging to factor F (percentage) • 5-40

M105 Machining with first Kv factor •
M106 Machining with second Kv factor •

M107 Suppress error message for replacement tool with oversize •
M108 Reset M107 •

M109 Constant contouring speed at tool cutting edge on circular arcs

(increase and decrease feed rate) • 5-41

M110 Constant contouring speed at tool cutting edge on circular arcs

(feed rate decrease only) • 5-41

M111 Reset M109/M110 • 5-41

M112 Automatic insertion of rounding arcs at non-tangential straight-line

transitions; Enter tolerance T for contour deviation • 5-41

M113 Reset M112 •

M114 Automatic compensation of machine geometry during operation

with tilting axes • 5-42

M115 Reset M114 •

M116 Feed rate for angular axes in mm/min • 5-43

M126 Optimized traverse of rotary axes • 5-44
M127 Reset M126 •