HEIDENHAIN TNC 407 (280 580) ISO Programming - Manual (Page 24)

TNC 426/TNC 425/TNC 415 B/TNC 407 1-6
1 Introduction
1.1 The TNC 400 Series
Screen layout
You can select the type of display on the TNC screen by pressing the
SPLIT SCREEN key and one of the soft keys listed below. Depending on
the active mode of operation, you can select:
Mode of operation Screen layout Soft key
MANUAL Positions
ELECTRONIC HANDWHEEL
Left: positions
Right: STATUS
POSITIONING WITH MDI Program blocks
Left: program blocks
Right: STATUS
PROGRAM RUN/FULL SEQUENCE Program blocks
PROGRAM RUN/SINGLE BLOCK
TEST RUN
Left: program blocks
Right: program structure
(
conversational programming only)
Left: program blocks
Right: STATUS
Left: program blocks
Right: graphics
Graphics
PROGRAMMING AND EDITING No screen selection possible, the TNC
displays program blocks only