HEIDENHAIN TNC 407 (280 580) ISO Programming - Manual (Page 292)

1 0 - 5
10 MOD Functions
TNC 426/TNC 425/TNC 415 B/TNC 407
10.4 Setting the External Data Interfaces
ASSIGN
This function sets the destination for the transferred data.
Applications:
• Transferring values with Q parameter function D15
• Transferring values with Q parameter function D16 (only with TNC 426)
• Path on the TNC's hard disk in which the digitized data are stored (only
with TNC 426)
The TNC mode of operation determines whether the PRINT or PRINT-
TEST function is used:
TNC mode of operation Transfer
function
PROGRAM RUN, SINGLE BLOCK PRINT
PROGRAM RUN, FULL SEQUENCE PRINT
TEST RUN PRINT-TEST
You can set PRINT and PRINT-TEST as follows:
Function Path to be entered Setting
(TNC 426) (TNC 407/TNC 415 B/TNC 425)
Transfer data with D15/D16 via RS-232 RS232:\........... RS-232
Transfer data with D15/D16 via RS-422 RS422:\........... RS-422
Save data to the TNC's hard disk or
in the TNC memory
TNC:\........... FILE
Save data in directory in which the program
with D15/D16 is located (TNC 426).
Do not save data (TNC 407/TNC 415 B/TNC 425)
- vacant - - vacant -
File names
Data Mode of operation File name
Values with D15 PROGRAM RUN %D15RUN.A
Values with D15 TEST RUN %D15SIM.A
Values with D16 PROGRAM RUN %D16RUN.A
Values with D16 TEST RUN %D16SIM.A