HEIDENHAIN TNC 407 (280 580) ISO Programming - Manual (Page 49)

TNC 426/TNC 425/TNC 415 B/TNC 407 1 - 3 1
1 Introduction
1.5 File Management on the TNC 426
Calling the file manager
Press the PGM MGT key to call the file manager. The screen will then look
something like this:
Drives
Directories
Active path or
file name
Files stored in the
active directory
File information
With the WINDOW soft key you can change the screen layout (see page
1-34). Whenever you press the PGM MGT key, the TNC shows the screen
layout that you last selected.
Drives:
RS232 interface
RS422 interface
TNC disk drive
The active drive is shown in a different color.
The drive symbol depends on the selected
interface mode (see page 10-4).
Directories:
The TNC shows a subdirectory at the right of
and below its parent directory. The active
directory is depicted in a different color and
is indicated by an open file symbol.
File information:
• FILE NAME: Files stored in the active directory
• BYTES: Size of the file in bytes
• STATUS: The following letters may appear in the STATUS
column:
E : File is selected in the PROGRAMMING AND
EDITING operating mode
S: File is selected in the TEST RUN operating
mode
M: File is selected in a program run operating
mode
P : File is protected against editing and erasure
IN: File contains inch dimensions
W: File was incompletely transferred to
external storage and cannot be run
• DATE: Date the file was last changed
• TIME: Time the file was last changed