HEIDENHAIN TNC 407 (280 580) ISO Programming User Manual
Page 324
11-27
11
Tables, Overviews and Diagrams
TNC 426/TNC 425/TNC 415 B/TNC 407
TNC error messages during test run and program run
ANGLE REFERENCE MISSING
• Complete your definition of the arc and its end points.
• If you enter polar coordinates, define the polar coordinate angle correctly.
ARITHMETICAL ERROR
You have calculated with non-permissible values.
• Define values within the range limits
• Choose probe positions for the 3D touch probe that are farther apart
• All calculations must be mathematically possible
AXIS DOUBLE PROGRAMMED
Each axis can have only one value for position coordinates.
BLK FORM DEFINITION INCORRECT
• Program the MIN and MAX points according to the instructions.
• Choose a ratio of sides that is less than 200:1.
CHAMFER NOT PERMITTED
A chamfer block must be located between two straight line blocks with identical radius compensation.
CIRCLE CENTER UNDEFINED
• Define a circle center with I,J (JK, IK).
• Define a pole with I,J (JK, IK).
CIRCLE END POS. INCORRECT
• Enter complete information for connecting arc.
• Enter end points that lie on the circular path.
CYCL INCOMPLETE
• Define the cycles with all data in the proper sequence.
• Do not call the coordinate transformation cycles.
• Define a cycle before calling it.
• Enter a pecking depth other than 0.