HEIDENHAIN TNC 407 (280 580) ISO Programming User Manual
Page 317
11-20
11
Tables, Overviews and Diagrams
TNC 426/TNC 425/TNC 415 B/TNC 407
Overlap factor: Q112
The overlap factor for pocket milling (MP 7430) is assigned to Q112.
Unit of measurement for dimensions in the part program: Q113
The value of parameter Q113 specifies whether the highest-level NC
program (for nesting with %) is programmed in millimeters or inches.
Dimensions of the main program
Parameter value
Metric system (mm)
Q113 =
0
Inch system
Q113 =
1
Tool length: Q114
The current value for the tool length is assigned to Q114.
Coordinates after probing during program run
Q115 to Q119 contain the coordinates of the spindle position at the
moment of contact during programmed measurement with the 3D touch
probe. The length and radius of the probe tip are not compensated in
these coordinates.
Coordinate axis
Parameter
X axis
Q115
Y axis
Q116
Z axis
Q117
IVth axis
Q118
Vth axis
Q119
Deviation between actual value and nominal value during automatic tool measurement
with the TT 110 touch probe (
conversational programming only)
Actual-nominal deviation
Parameter
Tool length
Q115
Tool radius
Q116
Tilting the working plane with mathematical angles: Rotary axis coordinates calculated by the TNC
Coordinates
Parameter
A axis
Q120
B axis
Q121
C axis
Q122
425
415
407