beautypg.com

Delta Electronics Human Machine Interface DOP-A Series User Manual

Page 264

background image

Chapter 4 Macro Function|ScrEdit Software User Manual

Revision Apr. 30th, 2007, 2007PDD23000002

4-43

„

Code–107: There is RET in Macro

This error message means that there is RET command in Macro. RET command should be used for

sub-macro to return program. It means that the program does not finish. If the program needs to be

finished in Macro, please use END, not RET.

„

HMI Macro Error Messages

The user can read error messages by macro. Once there is an error and the user execute’s a correct

command before reading error message, the error message will be overwritten. When executing each macro,

each Macro error message will not be influenced by another macro.

„

Code–10: GOTO Error

This message means that there is GOTO error in macro.

„

Code–11: Stack Overflow

This message means that stack in macro is full. That may be cause by using too many sub-macros or

execute different macros at the same time. This is to avoid insufficient memory.

„

Code–12: CALL Empty Sub-macro

This is CALL sub-macro error. The sub-macro that is called should not be an empty sub-macro. This

message is to avoid unexpected error.

„

Code–13: Data Read Error

This is data read error. Sometimes this may be caused by memory data error but most of the time is the

controller data read error.

„

Code–14: Data Write Error

This is data write error. Sometimes this may be caused by memory data error but most of the time is

the controller data write error.

„

Code–15: Divisor is 0

This error message means that the devisor is 0 when performing division operation.

This manual is related to the following products: