Microsens MS453490M Management Guide - Manual (Page 943)

C HAPTER 41 | IP Interface Commands
IPv6 Interface
– 943 –
response time: 0 ms [FE80::2E0:CFF:FE00:FC] seq_no: 4
response time: 0 ms [FE80::2E0:CFF:FE00:FC] seq_no: 5
Ping statistics for FE80::2E0:CFF:FE00:FC%1/64:
5 packets transmitted, 5 packets received (100%), 0 packets lost (0%)
Approximate round trip times:
Minimum = 0 ms, Maximum = 20 ms, Average = 4 ms
Console#
ipv6 nd dad
attempts
This command configures the number of consecutive neighbor solicitation
messages sent on an interface during duplicate address detection. Use the
no form to restore the default setting.
S YNTAX
ipv6 nd dad attempts count
no ipv6 nd dad attempts
count - The number of neighbor solicitation messages sent to
determine whether or not a duplicate address exists on this
interface. (Range: 0-600)
D EFAULT S ETTING
1
C OMMAND M ODE
Interface Configuration (VLAN)
C OMMAND U SAGE
◆ Configuring a value of 0 disables duplicate address detection.
◆ Duplicate address detection determines if a new unicast IPv6 address
already exists on the network before it is assigned to an interface.
◆ Duplicate address detection is stopped on any interface that has been
suspended (see the vlan command). While an interface is suspended,
all unicast IPv6 addresses assigned to that interface are placed in a
“pending” state. Duplicate address detection is automatically restarted
when the interface is administratively re-activated.
◆ An interface that is re-activated restarts duplicate address detection for
all unicast IPv6 addresses on the interface. While duplicate address
detection is performed on the interface’s link-local address, the other
IPv6 addresses remain in a “tentative” state. If no duplicate link-local
address is found, duplicate address detection is started for the
remaining IPv6 addresses.
◆ If a duplicate address is detected, it is set to “duplicate” state, and a
warning message is sent to the console. If a duplicate link-local address
is detected, IPv6 processes are disabled on the interface. If a duplicate
global unicast address is detected, it is not used. All configuration
commands associated with a duplicate address remain configured while
the address is in “duplicate” state.