Microsens MS453490M Management Guide - Manual (Page 870)

C HAPTER 37 | Multicast Filtering Commands
IGMP Filtering and Throttling
– 870 –
ip igmp profile This command creates an IGMP filter profile number and enters IGMP
profile configuration mode. Use the no form to delete a profile number.
S YNTAX
[no] ip igmp profile profile-number
profile-number - An IGMP filter profile number.
(Range: 1-4294967295)
D EFAULT S ETTING
Disabled
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
A profile defines the multicast groups that a subscriber is permitted or
denied to join. The same profile can be applied to many interfaces, but only
one profile can be assigned to one interface. Each profile has only one
access mode; either permit or deny.
E XAMPLE
Console(config)#ip igmp profile 19
Console(config-igmp-profile)#
permit, deny This command sets the access mode for an IGMP filter profile. Use the no
form to delete a profile number.
S YNTAX
{permit | deny}
D EFAULT S ETTING
Deny
C OMMAND M ODE
IGMP Profile Configuration
C OMMAND U SAGE
◆ Each profile has only one access mode; either permit or deny.
◆ When the access mode is set to permit, IGMP join reports are
processed when a multicast group falls within the controlled range.
When the access mode is set to deny, IGMP join reports are only
processed when a multicast group is not in the controlled range.