Microsens MS453490M Management Guide - Manual (Page 493)

– 493 –
21
S
YSTEM
M
ANAGEMENT
C
OMMANDS
These commands are used to control system logs, passwords, user names,
management options, and display or configure a variety of other system
information.
D EVICE D ESIGNATION
This section describes commands used to configure information that
uniquely identifies the switch.
Table 37: System Management Commands
Command Group Function
Device Designation Configures information that uniquely identifies this switch
Banner Information Configures administrative contact, device identification and
location
System Status Displays system configuration, active managers, and version
information
Frame Size Enables support for jumbo frames
File Management Manages code image or switch configuration files
Line Sets communication parameters for the serial port, including baud
rate and console time-out
Event Logging Controls logging of error messages
SMTP Alerts Configures SMTP email alerts
Time (System Clock) Sets the system clock automatically via NTP/SNTP server or
manually
Time Range Sets a time range for use by other functions, such as Access
Control Lists
Switch Clustering Configures management of multiple devices via a single IP
address
Table 38: Device Designation Commands
Command Function Mode
hostname Specifies the host name for the switch GC
snmp-server contact Sets the system contact string GC
snmp-server location Sets the system location string GC