Microsens MS453490M Management Guide - Manual (Page 625)

C HAPTER 24 | Authentication Commands
802.1X Port Authentication
– 625 –
C OMMAND M ODE
Interface Configuration
E XAMPLE
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout quiet-period 350
Console(config-if)#
dot1x timeout re-
authperiod
This command sets the time period after which a connected client must be
re-authenticated. Use the no form of this command to reset the default.
S YNTAX
dot1x timeout re-authperiod seconds
no dot1x timeout re-authperiod
seconds - The number of seconds. (Range: 1-65535)
D EFAULT
3600 seconds
C OMMAND M ODE
Interface Configuration
E XAMPLE
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout re-authperiod 300
Console(config-if)#
dot1x timeout supp-
timeout
This command sets the time that an interface on the switch waits for a
response to an EAP request from a client before re-transmitting an EAP
packet. Use the no form to reset to the default value.
S YNTAX
dot1x timeout supp-timeout seconds
no dot1x timeout supp-timeout
seconds - The number of seconds. (Range: 1-65535)
D EFAULT
30 seconds
C OMMAND M ODE
Interface Configuration