Microsens MS453490M Management Guide - Manual (Page 385)

C HAPTER 15 | Basic Administration Protocols
Simple Network Management Protocol
– 385 –
W EB I NTERFACE
To configure a local SNMPv3 user:
1. Click Administration, SNMP.
2. Select Configure User from the Step list.
3. Select Add SNMPv3 Local User from the Action list.
4. Enter a name and assign it to a group. If the security model is set to
SNMPv3 and the security level is authNoPriv or authPriv, then an
authentication protocol and password must be specified. If the security
level is authPriv, a privacy password must also be specified.
5. Click Apply
Figure 225: Configuring Local SNMPv3 Users
To show local SNMPv3 users:
1. Click Administration, SNMP.
2. Select Configure User from the Step list.
3. Select Show SNMPv3 Local User from the Action list.