Microsens MS453490M Management Guide - Manual (Page 679)

C HAPTER 25 | General Security Measures
ARP Inspection
– 679 –
C OMMAND M ODE
Interface Configuration (Port)
C OMMAND U SAGE
◆ This command only applies to untrusted ports.
◆ When the rate of incoming ARP packets exceeds the configured limit,
the switch drops all ARP packets in excess of the limit.
E XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#ip arp inspection limit 150
Console(config-if)#
ip arp inspection
trust
This command sets a port as trusted, and thus exempted from ARP
Inspection. Use the no form to restore the default setting.
S YNTAX
[no] ip arp inspection trust
D EFAULT S ETTING
Untrusted
C OMMAND M ODE
Interface Configuration (Port)
C OMMAND U SAGE
Packets arriving on untrusted ports are subject to any configured ARP
Inspection and additional validation checks. Packets arriving on trusted
ports bypass all of these checks, and are forwarded according to normal
switching rules.
E XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#ip arp inspection trust
Console(config-if)#