Microsens MS453490M Management Guide - Manual (Page 708)

C HAPTER 27 | Interface Commands
– 708 –
clear counters This command clears statistics on an interface.
S YNTAX
clear counters interface
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10)
port-channel channel-id (Range: 1-5)
D EFAULT S ETTING
None
C OMMAND M ODE
Privileged Exec
C OMMAND U SAGE
Statistics are only initialized for a power reset. This command sets the base
value for displayed statistics to zero for the current management session.
However, if you log out and back into the management interface, the
statistics displayed will show the absolute value accumulated since the last
power reset.
E XAMPLE
The following example clears statistics on port 5.
Console#clear counters ethernet 1/5
Console#
show interfaces
brief
This command displays a summary of key information, including
operational status, native VLAN ID, default priority, speed/duplex mode,
and port type for all ports.
C OMMAND M ODE
Privileged Exec
E XAMPLE
Console#show interfaces brief
Interface Name Status PVID Pri Speed/Duplex Type Trunk
--------- ------------------ -------- ---- --- ------------- ------------ ---
Eth 1/ 1 Up 1 0 Auto-100full 100TX None
Eth 1/ 2 Down 1 0 Auto 100TX None
Eth 1/ 3 Down 1 0 Auto 100TX None
Eth 1/ 4 Down 1 0 Auto 100TX None
Eth 1/ 5 Down 1 0 Auto 100TX None
Eth 1/ 6 Down 1 0 Auto 100TX None
.
.
.