Lldp commands, 38 lldp c, Ommands – Microsens MS453490M Management Guide User Manual
Page 883: Table 129: lldp commands, Lldp c
– 883 –
38
LLDP C
OMMANDS
Link Layer Discovery Protocol (LLDP) is used to discover basic information
about neighboring devices on the local broadcast domain. LLDP is a Layer 2
protocol that uses periodic broadcasts to advertise information about the
sending device. Advertised information is represented in Type Length Value
(TLV) format according to the IEEE 802.1ab standard, and can include
details such as device identification, capabilities and configuration settings.
LLDP also defines how to store and maintain information gathered about
the neighboring network nodes it discovers.
Table 129: LLDP Commands
Command
Function
Mode
Enables LLDP globally on the switch
GC
Configures the time-to-live (TTL) value sent in
LLDP advertisements
GC
Configures the allowed interval for sending
SNMP notifications about LLDP changes
GC
Configures the periodic transmit interval for
LLDP advertisements
GC
Configures the delay before attempting to re-
initialize after LLDP ports are disabled or the link
goes down
GC
Configures a delay between the successive
transmission of advertisements initiated by a
change in local LLDP MIB variables
GC
Enables LLDP transmit, receive, or transmit and
receive mode on the specified port
IC
Configures an LLDP-enabled port to advertise
the management address for this device
IC
Configures an LLDP-enabled port to advertise its
port description
IC
Configures an LLDP-enabled port to advertise its
system capabilities
IC
Configures an LLDP-enabled port to advertise
the system description
IC
Configures an LLDP-enabled port to advertise its
system name
IC
*
Configures an LLDP-enabled port to advertise
the supported protocols
IC
*
Configures an LLDP-enabled port to advertise
port related VLAN information
IC
Configures an LLDP-enabled port to advertise its
default VLAN ID
IC
Configures an LLDP-enabled port to advertise its
VLAN name
IC