Microsens MS453490M Management Guide - Manual (Page 538)

C HAPTER 21 | System Management Commands
SMTP Alerts
– 538 –
E XAMPLE
Console(config)#logging sendmail host 192.168.1.19
Console(config)#
logging sendmail
level
This command sets the severity threshold used to trigger alert messages.
Use the no form to restore the default setting.
S YNTAX
logging sendmail level level
no logging sendmail level
level - One of the system message levels ( page 531 ). Messages
sent include the selected level down to level 0. (Range: 0-7;
Default: 7)
D EFAULT S ETTING
Level 7
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
The specified level indicates an event threshold. All events at this level or
higher will be sent to the configured email recipients. (For example, using
Level 7 will report all events from level 7 to level 0.)
E XAMPLE
This example will send email alerts for system errors from level 3 through
0.
Console(config)#logging sendmail level 3
Console(config)#
logging sendmail
destination-email This command specifies the email recipients of alert messages. Use the no
form to remove a recipient.
S YNTAX
[no] logging sendmail destination-email email-address
email-address - The source email address used in alert messages.
(Range: 1-41 characters)
D EFAULT S ETTING
None