Microsens MS453490M Management Guide - Manual (Page 150)

C HAPTER 5 | Interface Configuration
Traffic Segmentation
– 150 –
T RAFFIC S EGMENTATION
If tighter security is required for passing traffic from different clients
through downlink ports on the local network and over uplink ports to the
service provider, port-based traffic segmentation can be used to isolate
traffic between clients on different downlink ports. Data traffic on downlink
ports is only forwarded to, and from, uplink ports.
E NABLING T RAFFIC
S EGMENTATION
Use the Interface > Traffic Segmentation (Configure Global) page to enable
traffic segmentation.
CLI R EFERENCES
◆ "Configuring Port-based Traffic Segmentation" on page 800
P ARAMETERS
These parameters are displayed:
◆ Status – Enables port-based traffic segmentation. (Default: Disabled)
W EB I NTERFACE
To enable traffic segmentation:
1. Click Interface, Traffic Segmentation.
2. Select Configure Global from the Step list.
3. Mark the Enabled check box.
4. Click Apply.
Figure 53: Enabling Traffic Segmentation