Microsens MS453490M Management Guide - Manual (Page 372)

C HAPTER 15 | Basic Administration Protocols
Simple Network Management Protocol
– 372 –
C ONFIGURING G LOBAL
S ETTINGS FOR SNMP
Use the Administration > SNMP (Configure Global) page to enable SNMPv3
service for all management clients (i.e., versions 1, 2c, 3), and to enable
trap messages.
CLI R EFERENCES
◆ "snmp-server" on page 556
◆ "snmp-server enable traps" on page 559
P ARAMETERS
These parameters are displayed:
◆ Agent Status – Enables SNMP on the switch. (Default: Enabled)
◆ Authentication Traps 5 – Issues a notification message to specified IP
trap managers whenever an invalid community string is submitted
during the SNMP access authentication process. (Default: Enabled)
◆ Link-up and Link-down Traps 5 – Issues a notification message
whenever a port link is established or broken. (Default: Enabled)
W EB I NTERFACE
To configure global settings for SNMP:
1.
Click Administration, SNMP.
2.
Select Configure Global from the Step list.
3.
Enable SNMP and the required trap types.
4.
Click Apply
Figure 213: Configuring Global Settings for SNMP
5. These are legacy notifications and therefore when used for SNMPv3 hosts, they must be
enabled in conjunction with the corresponding entries in the Notification View ( page 375 ).