Microsens MS453490M Management Guide - Manual (Page 536)

C HAPTER 21 | System Management Commands
SMTP Alerts
– 536 –
REMOTELOG Level Type: Debugging messages
REMOTELOG server IP Address: 1.2.3.4
REMOTELOG server IP Address: 0.0.0.0
REMOTELOG server IP Address: 0.0.0.0
REMOTELOG server IP Address: 0.0.0.0
REMOTELOG server IP Address: 0.0.0.0
Console#
R ELATED C OMMANDS
show logging sendmail (539)
SMTP A LERTS
These commands configure SMTP event handling, and forwarding of alert
messages to the specified SMTP servers and email recipients.
Table 48: show logging trap - display description
Field Description
Syslog logging Shows if system logging has been enabled via the logging on
command.
REMOTELOG status Shows if remote logging has been enabled via the logging trap
command.
REMOTELOG facility type The facility type for remote logging of syslog messages as
specified in the logging facility command.
REMOTELOG level type The severity threshold for syslog messages sent to a remote
server as specified in the logging trap command.
REMOTELOG
server IP address
The address of syslog servers as specified in the logging host
command.
Table 49: Event Logging Commands
Command Function Mode
logging sendmail Enables SMTP event handling GC
logging sendmail host SMTP servers to receive alert messages GC
logging sendmail level Severity threshold used to trigger alert messages GC
logging sendmail
destination-email
Email recipients of alert messages GC
logging sendmail source-
email
Email address used for “From” field of alert messages GC
show logging sendmail Displays SMTP event handler settings NE, PE