Microsens MS453490M Management Guide - Manual (Page 542)

C HAPTER 21 | System Management Commands
Time
– 542 –
R ELATED C OMMANDS
sntp client (540)
sntp server This command sets the IP address of the servers to which SNTP time
requests are issued. Use the this command with no arguments to clear all
time servers from the current list. Use the no form to clear all time servers
from the current list, or to clear a specific server.
S YNTAX
sntp server [ip1 [ip2 [ip3]]]
no sntp server [ip1 [ip2 [ip3]]]
ip - IP address of an time server (NTP or SNTP).
(Range: 1 - 3 addresses)
D EFAULT S ETTING
None
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
This command specifies time servers from which the switch will poll for
time updates when set to SNTP client mode. The client will poll the time
servers in the order specified until a response is received. It issues time
synchronization requests based on the interval set via the sntp poll
command.
E XAMPLE
Console(config)#sntp server 10.1.0.19
Console#
R ELATED C OMMANDS
sntp client (540)
sntp poll (541)
show sntp (542)
show sntp This command displays the current time and configuration settings for the
SNTP client, and indicates whether or not the local time has been properly
updated.
C OMMAND M ODE
Normal Exec, Privileged Exec
C OMMAND U SAGE
This command displays the current time, the poll interval used for sending
time synchronization requests, and the current SNTP mode (i.e., unicast).