Microsens MS453490M Management Guide - Manual (Page 588)

C HAPTER 24 | Authentication Commands
RADIUS Client
– 588 –
R ELATED C OMMANDS
username - for setting the local user names and passwords ( 585 )
RADIUS C LIENT
Remote Authentication Dial-in User Service (RADIUS) is a logon
authentication protocol that uses software running on a central server to
control access to RADIUS-aware devices on the network. An authentication
server contains a database of multiple user name/password pairs with
associated privilege levels for each user or group that require management
access to a switch.
radius-server acct-
port
This command sets the RADIUS server network port for accounting
messages. Use the no form to restore the default.
S YNTAX
radius-server acct-port port-number
no radius-server acct-port
port-number - RADIUS server UDP port used for accounting
messages. (Range: 1-65535)
D EFAULT S ETTING
1813
C OMMAND M ODE
Global Configuration
E XAMPLE
Console(config)#radius-server acct-port 181
Console(config)#
Table 63: RADIUS Client Commands
Command Function Mode
radius-server acct-port Sets the RADIUS server network port GC
radius-server auth-port Sets the RADIUS server network port GC
radius-server host Specifies the RADIUS server GC
radius-server key Sets the RADIUS encryption key GC
radius-server retransmit Sets the number of retries GC
radius-server timeout Sets the interval between sending authentication
requests
GC
show radius-server Shows the current RADIUS settings PE