Microsens MS453490M Management Guide - Manual (Page 869)

C HAPTER 37 | Multicast Filtering Commands
IGMP Filtering and Throttling
– 869 –
ip igmp filter (Global
Configuration)
This command globally enables IGMP filtering and throttling on the switch.
Use the no form to disable the feature.
S YNTAX
[no] ip igmp filter
D EFAULT S ETTING
Disabled
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
◆ IGMP filtering enables you to assign a profile to a switch port that
specifies multicast groups that are permitted or denied on the port. An
IGMP filter profile can contain one or more, or a range of multicast
addresses; but only one profile can be assigned to a port. When
enabled, IGMP join reports received on the port are checked against the
filter profile. If a requested multicast group is permitted, the IGMP join
report is forwarded as normal. If a requested multicast group is denied,
the IGMP join report is dropped.
◆ IGMP filtering and throttling only applies to dynamically learned
multicast groups, it does not apply to statically configured groups.
◆ The IGMP filtering feature operates in the same manner when MVR is
used to forward multicast traffic.
E XAMPLE
Console(config)#ip igmp filter
Console(config)#
ip igmp max-groups
action
Sets the IGMP throttling action for an interface IC
show ip igmp filter Displays the IGMP filtering status PE
show ip igmp profile Displays IGMP profiles and settings PE
show ip igmp throttle
interface
Displays the IGMP throttling setting for interfaces PE
Table 124: IGMP Filtering and Throttling Commands (Continued)
Command Function Mode