Ipv6 interface, Table 139: ipv6 configuration commands, Nterface – Microsens MS453490M Management Guide User Manual
Page 925
![background image](https://www.manualsdir.com/files/798575/content/doc925.png)
C
HAPTER
41
| IP Interface Commands
IPv6 Interface
– 925 –
IP
V
6 I
NTERFACE
This switch supports the following IPv6 interface commands.
Table 139: IPv6 Configuration Commands
Command
Function
Mode
Interface Address Configuration and Utilities
Sets an IPv6 default gateway for traffic
GC
Configures an IPv6 global unicast address, and
enables IPv6 on an interface
IC
Enables automatic configuration of IPv6 global unicast
addresses on an interface and enables IPv6 on the
interface
IC
Configures an IPv6 global unicast address for an
interface using an EUI-64 interface ID in the low order
64 bits, and enables IPv6 on the interface
IC
Configures an IPv6 link-local address for an interface
and enables IPv6 on the interface
IC
Enables IPv6 on an interface that has not been
configured with an explicit IPv6 address
IC
Sets the size of the maximum transmission unit (MTU)
for IPv6 packets sent on an interface
IC
Displays the current IPv6 default gateway
NE, PE
Displays the usability and configured settings for IPv6
interfaces
NE, PE
Displays maximum transmission unit (MTU)
information for IPv6 interfaces
NE, PE
Displays statistics about IPv6 traffic
NE, PE
Resets IPv6 traffic counters
PE
Sends IPv6 ICMP echo request packets to another
node on the network
PE
Neighbor Discovery
Configures the number of consecutive neighbor
solicitation messages sent on an interface during
duplicate address detection
IC
Configures the interval between IPv6 neighbor
solicitation retransmissions on an interface
IC
Configures the amount of time that a remote IPv6
node is considered reachable after some reachability
confirmation event has occurred
IC
Deletes all dynamic entries in the IPv6 neighbor
discovery cache
PE
Displays information in the IPv6 neighbor discovery
cache
PE