Microsens MS453490M Management Guide - Manual (Page 880)

C HAPTER 37 | Multicast Filtering Commands
Multicast VLAN Registration
– 880 –
show mvr This command shows information about the global MVR configuration
settings when entered without any keywords, the interfaces attached to
the MVR VLAN using the interface keyword, or the multicast groups
assigned to the MVR VLAN using the members keyword.
S YNTAX
show mvr [interface [interface] | members [ip-address]]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10)
port-channel channel-id (Range: 1-5)
ip-address - IP address for an MVR multicast group.
(Range: 224.0.1.0 - 239.255.255.255)
D EFAULT S ETTING
Displays global configuration settings for MVR when no keywords are used.
C OMMAND M ODE
Privileged Exec
C OMMAND U SAGE
Enter this command without any keywords to display the global settings for
MVR. Use the interface keyword to display information about interfaces
attached to the MVR VLAN. Or use the members keyword to display
information about multicast groups assigned to the MVR VLAN.
E XAMPLE
The following shows the global MVR settings:
Console#show mvr
MVR Config Status : Enabled
MVR Running Status : Active
MVR Multicast VLAN : 1
MVR Group Address : 225.0.0.5
MVR Group Count : 10
Console#
Table 126: show mvr - display description
Field Description
MVR Config Status Shows if MVR is globally enabled on the switch.
MVR Running Status Indicates whether or not all necessary conditions in the MVR
environment are satisfied. (Running status is true as long as MVR
Status is enabled, and the specified MVR VLAN exists.)
MVR Multicast VLAN Shows the VLAN used to transport all MVR multicast traffic.