Microsens MS453490M Management Guide - Manual (Page 533)

C HAPTER 2 1 | System Management Commands
Event Logging
– 533 –
R ELATED C OMMANDS
logging history (531)
logging trap (533)
clear log (533)
logging trap This command enables the logging of system messages to a remote server,
or limits the syslog messages saved to a remote server based on severity.
Use this command without a specified level to enable remote logging. Use
the no form to disable remote logging.
S YNTAX
logging trap [level level]
no logging trap [level]
level - One of the syslog severity levels listed in the table on
page 531 . Messages sent include the selected level through level 0.
D EFAULT S ETTING
Disabled
Level 7
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
◆ Using this command with a specified level enables remote logging and
sets the minimum severity level to be saved.
◆ Using this command without a specified level also enables remote
logging, but restores the minimum severity level to the default.
E XAMPLE
Console(config)#logging trap 4
Console(config)#
clear log This command clears messages from the log buffer.
S YNTAX
clear log [flash | ram]
flash - Event history stored in flash memory (i.e., permanent
memory).
ram - Event history stored in temporary RAM (i.e., memory flushed
on power reset).
D EFAULT S ETTING
Flash and RAM