Microsens MS453490M Management Guide - Manual (Page 502)

C HAPTER 21 | System Management Commands
Banner Information
– 502 –
D EFAULT S ETTING
None
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
Input strings cannot contain spaces. The banner configure mux
command interprets spaces as data input boundaries. The use of
underscores ( _ ) or other unobtrusive non-letter characters is suggested
for situations where white space is necessary for clarity.
E XAMPLE
Console(config)#banner configure mux telco-8734212kx_PVC-1/23
Console(config)#
banner configure
note
This command is used to configure the note displayed in the banner. Use
the no form to restore the default setting.
S YNTAX
banner configure note note-info
no banner configure note
note-info - Miscellaneous information that does not fit the other
banner categories, or any other information of importance to users
of the switch CLI. (Maximum length: 150 characters)
D EFAULT S ETTING
None
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
Input strings cannot contain spaces. The banner configure note
command interprets spaces as data input boundaries. The use of
underscores ( _ ) or other unobtrusive non-letter characters is suggested
for situations where white space is necessary for clarity.
E XAMPLE
Console(config)#banner configure note !!!!!ROUTINE_MAINTENANCE_firmware-
upgrade_0100-0500_GMT-0500_20071022!!!!!_20min_network_impact_expected
Console(config)#