Switchport allowed vlan – Microsens MS453490M Management Guide User Manual
Page 790
C
HAPTER
34
| VLAN Commands
Configuring VLAN Interfaces
– 790 –
tagged - The port only receives tagged frames.
D
EFAULT
S
ETTING
All frame types
C
OMMAND
M
ODE
Interface Configuration (Ethernet, Port Channel)
C
OMMAND
U
SAGE
When set to receive all frame types, any received frames that are untagged
are assigned to the default VLAN.
E
XAMPLE
The following example shows how to restrict the traffic received on port 1
to tagged frames:
Console(config)#interface ethernet 1/1
Console(config-if)#switchport acceptable-frame-types tagged
Console(config-if)#
R
ELATED
C
OMMANDS
switchport allowed
vlan
This command configures VLAN groups on the selected interface. Use the
no form to restore the default.
S
YNTAX
switchport allowed vlan {add vlan-list [tagged | untagged] |
remove vlan-list}
no switchport allowed vlan
add vlan-list - List of VLAN identifiers to add.
remove vlan-list - List of VLAN identifiers to remove.
vlan-list - Separate nonconsecutive VLAN identifiers with a comma
and no spaces; use a hyphen to designate a range of IDs. Do not
enter leading zeros. (Range: 1-4093).
D
EFAULT
S
ETTING
All ports are assigned to VLAN 1 by default.
The default frame type is untagged.
C
OMMAND
M
ODE
Interface Configuration (Ethernet, Port Channel)
C
OMMAND
U
SAGE
◆
A port, or a trunk with switchport mode set to hybrid, must be
assigned to at least one VLAN as untagged.