Microsens MS453490M Management Guide User Manual

Page 413

HAPTER

| IP Configuration

Setting the Switch’s IP Address (IP Version 4)

– 413 –

CLI R

EFERENCES

◆

◆

ARAMETERS

These parameters are displayed:

◆

Management VLAN – ID of the configured VLAN (1-4093). By default,

all ports on the switch are members of VLAN 1. However, the

management station can be attached to a port belonging to any VLAN,

as long as that VLAN has been assigned an IP address.

◆

IP Address Mode – Specifies whether IP functionality is enabled via

manual configuration (Static), Dynamic Host Configuration Protocol

(DHCP), or Boot Protocol (BOOTP). If DHCP/BOOTP is enabled, IP will

not function until a reply has been received from the server. Requests

will be broadcast periodically by the switch for an IP address. DHCP/

BOOTP responses can include the IP address, subnet mask, and default

gateway. (Default: Static)

◆

IP Address – Address of the VLAN to which the management station is

attached. Valid IP addresses consist of four numbers, 0 to 255,

separated by periods. (Default: 192.168.1.10)

◆

Subnet Mask – This mask identifies the host address bits used for

routing to specific subnets. (Default: 255.255.255.0)

◆

Gateway IP Address – IP address of the gateway router between the

switch and management stations that exist on other network

segments. (Default: 0.0.0.0)

◆

MAC Address – The physical layer address for this switch.

◆

Restart DHCP – Requests a new IP address from the DHCP server.