Microsens MS453490M Management Guide - Manual (Page 282)

C HAPTER 14 | Security Measures
Network Access (MAC Address Authentication)
– 282 –
4. Make any configuration changes required to enable address
authentication on a port, set the maximum number of secure addresses
supported, the guest VLAN to use when MAC Authentication or 802.1X
Authentication fails, and the dynamic VLAN and QoS assignments.
5. Click Apply.
Figure 155: Configuring Interface Settings for Network Access
C ONFIGURING P ORT
L INK D ETECTION
Use the Security > Network Access (Configure Interface - Link Detection)
page to send an SNMP trap and/or shut down a port when a link event
occurs.
CLI R EFERENCES
◆ "Network Access (MAC Address Authentication)" on page 641
P ARAMETERS
These parameters are displayed:
◆ Link Detection Status – Configures whether Link Detection is enabled
or disabled for a port.
◆ Condition – The link event type which will trigger the port action.
■
Link up – Only link up events will trigger the port action.
■
Link down – Only link down events will trigger the port action.
■
Link up and down – All link up and link down events will trigger
the port action.
◆ Action – The switch can respond in three ways to a link up or down
trigger event.
■
Trap – An SNMP trap is sent.
■
Trap and shutdown – An SNMP trap is sent and the port is shut
down.
■
Shutdown – The port is shut down.