Microsens MS453490M Management Guide - Manual (Page 884)

C HAPTER 38 | LLDP Commands
– 884 –
lldp This command enables LLDP globally on the switch. Use the no form to
disable LLDP.
S YNTAX
[no] lldp
D EFAULT S ETTING
Enabled
C OMMAND M ODE
Global Configuration
E XAMPLE
Console(config)#lldp
Console(config)#
lldp holdtime-
multiplier
This command configures the time-to-live (TTL) value sent in LLDP
advertisements. Use the no form to restore the default setting.
S YNTAX
lldp holdtime-multiplier value
no lldp holdtime-multiplier
value - Calculates the TTL in seconds based on
(holdtime-multiplier * refresh-interval) ≤
65536
(Range: 2 - 10)
lldp dot3-tlv link-agg Configures an LLDP-enabled port to advertise its
link aggregation capabilities
IC
lldp dot3-tlv mac-phy Configures an LLDP-enabled port to advertise its
MAC and physical layer specifications
IC
lldp dot3-tlv max-
frame
Configures an LLDP-enabled port to advertise its
maximum frame size
IC
lldp notification Enables the transmission of SNMP trap
notifications about LLDP changes
IC
show lldp config Shows LLDP configuration settings for all ports PE
show lldp info local-
device
Shows LLDP global and interface-specific
configuration settings for this device
PE
show lldp info remote-
device
Shows LLDP global and interface-specific
configuration settings for remote devices
PE
show lldp info statistics Shows statistical counters for all LLDP-enabled
interfaces
PE
* Vendor-specific options may or may not be advertised by neighboring devices.
Table 129: LLDP Commands (Continued)
Command Function Mode