Configuring https, Configuring global settings for https, Https – Microsens MS453490M Management Guide User Manual
Page 286
C
HAPTER
14
| Security Measures
Configuring HTTPS
– 286 –
Figure 159: Showing Addresses Authenticated for Network Access
C
ONFIGURING
HTTPS
You can configure the switch to enable the Secure Hypertext Transfer
Protocol (HTTPS) over the Secure Socket Layer (SSL), providing secure
access (i.e., an encrypted connection) to the switch’s web interface.
C
ONFIGURING
G
LOBAL
S
ETTINGS
FOR
HTTPS
Use the Security > HTTPS (Configure Global) page to enable or disable
HTTPS and specify the UDP port used for this service.
CLI R
EFERENCES
◆
C
OMMAND
U
SAGE
◆
Both the HTTP and HTTPS service can be enabled independently on the
switch. However, you cannot configure both services to use the same
UDP port. (HTTP can only be configured through the CLI using the
.)
◆
If you enable HTTPS, you must indicate this in the URL that you specify
in your browser: https://device[:port_number]
◆
When you start HTTPS, the connection is established in this way:
■
The client authenticates the server using the server’s digital
certificate.
■
The client and server negotiate a set of security protocols to use for
the connection.
■
The client and server generate session keys for encrypting and
decrypting data.