Microsens MS453490M Management Guide - Manual (Page 559)

C HAPTER 22 | SNMP Commands
– 559 –
Console#show snmp
SNMP Agent : Enabled
SNMP Traps :
Authentication : Enabled
Link-up-down : Enabled
SNMP Communities :
1. public, and the access level is read-only
2. private, and the access level is read/write
0 SNMP packets input
0 Bad SNMP version errors
0 Unknown community name
0 Illegal operation for community name supplied
0 Encoding errors
0 Number of requested variables
0 Number of altered variables
0 Get-request PDUs
0 Get-next PDUs
0 Set-request PDUs
0 SNMP packets output
0 Too big errors
0 No such name errors
0 Bad values errors
0 General errors
0 Response PDUs
0 Trap PDUs
SNMP Logging: Disabled
Console#
snmp-server enable
traps
This command enables this device to send Simple Network Management
Protocol traps or informs (i.e., SNMP notifications). Use the no form to
disable SNMP notifications.
S YNTAX
[no] snmp-server enable traps [authentication | link-up-down]
authentication - Keyword to issue authentication failure
notifications.
link-up-down - Keyword to issue link-up or link-down notifications.
D EFAULT S ETTING
Issue authentication and link-up-down traps.
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
◆ If you do not enter an snmp-server enable traps command, no
notifications controlled by this command are sent. In order to configure
this device to send SNMP notifications, you must enter at least one
snmp-server enable traps command. If you enter the command with