Microsens MS453490M Management Guide - Manual (Page 700)

C HAPTER 27 | Interface Commands
– 700 –
interface This command configures an interface type and enter interface
configuration mode. Use the no form with a trunk to remove an inactive
interface. Use the no form with a Layer 3 VLAN (normal type) to change it
back to a Layer 2 interface.
S YNTAX
[no] interface interface
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10)
port-channel channel-id (Range: 1-5)
vlan vlan-id (Range: 1-4093)
D EFAULT S ETTING
None
C OMMAND M ODE
Global Configuration
E XAMPLE
To specify port 4, enter the following command:
Console(config)#interface ethernet 1/4
Console(config-if)#
alias This command configures an alias name for the interface. Use the no form
to remove the alias name.
S YNTAX
alias string
no alias
string - A mnemonic name to help you remember what is attached
to this interface. (Range: 1-64 characters)
D EFAULT S ETTING
None
C OMMAND M ODE
Interface Configuration (Ethernet, Port Channel)