Microsens MS453490M Management Guide - Manual (Page 856)

C HAPTER 37 | Multicast Filtering Commands
IGMP Snooping
– 856 –
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
Once the table used to store multicast entries for IGMP snooping and
multicast routing is filled, no new entries are learned. If no router port is
configured in the attached VLAN, and unregistered-flooding is disabled,
any subsequent multicast traffic not found in the table is dropped,
otherwise it is flooded throughout the VLAN.
E XAMPLE
Console(config)#ip igmp snooping unregistered-data-flood
Console(config)#
ip igmp snooping
unsolicited-report-
interval
This command specifies how often the upstream interface should transmit
unsolicited IGMP reports when proxy reporting is enabled. Use the no form
to restore the default value.
S YNTAX
ip igmp snooping unsolicited-report-interval seconds
no ip igmp snooping version-exclusive
seconds - The interval at which to issue unsolicited reports.
(Range: 1-65535 seconds)
D EFAULT S ETTING
400 seconds
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
◆ When a new upstream interface (that is, uplink port) starts up, the
switch sends unsolicited reports for all currently learned multicast
channels out through the new upstream interface.
◆ This command only applies when proxy reporting is enabled (see
page 851 ).
E XAMPLE
Console(config)#ip igmp snooping unsolicited-report-interval 5
Console(config)#