Microsens MS453490M Management Guide - Manual (Page 619)

C HAPTER 24 | Authentication Commands
802.1X Port Authentication
– 619 –
802.1X P ORT A UTHENTICATION
The switch supports IEEE 802.1X (dot1x) port-based access control that
prevents unauthorized access to the network by requiring users to first
submit credentials for authentication. Client authentication is controlled
centrally by a RADIUS server using EAP (Extensible Authentication
Protocol).
Table 71: 802.1X Port Authentication Commands
Command Function Mode
General Commands
dot1x default Resets all dot1x parameters to their default values GC
dot1x eapol-pass-through Passes EAPOL frames to all ports in STP forwarding
state when dot1x is globally disabled
GC
dot1x system-auth-control Enables dot1x globally on the switch. GC
Authenticator Commands
dot1x intrusion-action Sets the port response to intrusion when
authentication fails
IC
dot1x max-req Sets the maximum number of times that the switch
retransmits an EAP request/identity packet to the
client before it times out the authentication session
IC
dot1x operation-mode Allows single or multiple hosts on an dot1x port IC
dot1x port-control Sets dot1x mode for a port interface IC
dot1x re-authentication Enables re-authentication for all ports IC
dot1x timeout quiet-period Sets the time that a switch port waits after the Max
Request Count has been exceeded before attempting
to acquire a new client
IC
dot1x timeout re-
authperiod
Sets the time period after which a connected client
must be re-authenticated
IC
dot1x timeout supp-timeout Sets the interval for a supplicant to respond IC
dot1x timeout tx-period Sets the time period during an authentication session
that the switch waits before re-transmitting an EAP
packet
IC
dot1x re-authenticate Forces re-authentication on specific ports PE
Supplicant Commands
dot1x identity profile Configures dot1x supplicant user name and password GC
dot1x max-start Sets the maximum number of times that a port
supplicant will send an EAP start frame to the client
IC
dot1x pae supplicant Enables dot1x supplicant mode on an interface IC
dot1x timeout auth-period Sets the time that a supplicant port waits for a
response from the authenticator
IC
dot1x timeout held-period Sets the time a port waits after the maximum start
count has been exceeded before attempting to find
another authenticator
IC