Microsens MS453490M Management Guide - Manual (Page 886)

C HAPTER 38 | LLDP Commands
– 886 –
lldp refresh-interval This command configures the periodic transmit interval for LLDP
advertisements. Use the no form to restore the default setting.
S YNTAX
lldp refresh-interval seconds
no lldp refresh-delay
seconds - Specifies the periodic interval at which LLDP
advertisements are sent. (Range: 5 - 32768 seconds)
D EFAULT S ETTING
30 seconds
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
This attribute must comply with the following rule:
(refresh-interval * holdtime-multiplier) ≤
65536
E XAMPLE
Console(config)#lldp refresh-interval 60
Console(config)#
lldp reinit-delay This command configures the delay before attempting to re-initialize after
LLDP ports are disabled or the link goes down. Use the no form to restore
the default setting.
S YNTAX
lldp reinit-delay seconds
no lldp reinit-delay
seconds - Specifies the delay before attempting to re-initialize LLDP.
(Range: 1 - 10 seconds)
D EFAULT S ETTING
2 seconds
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
When LLDP is re-initialized on a port, all information in the remote systems
LLDP MIB associated with this port is deleted.