Microsens MS453490M Management Guide - Manual (Page 711)

C HAPTER 27 | Interface Commands
– 711 –
Speed-duplex : Auto
Capabilities : 10half, 10full, 100half, 100full
Broadcast Storm : Enabled
Broadcast Storm Limit : 500 packets/second
Multicast Storm : Disabled
Multicast Storm Limit : 64 Kbits/second
Unknown Unicast Storm : Disabled
Unknown Unicast Storm Limit : 64 Kbits/second
Flow Control : Disabled
LACP : Disabled
Mac-Learning : Yes
Port Security : Disabled
Max MAC Count : 0
Port Security Action : None
Media Type : Copper forced
Current Status:
Link Status : Up
Port Operation Status : Up
Operation Speed-duplex : 100full
Flow Control Type : None
Console#
show interfaces
switchport
This command displays the administrative and operational status of the
specified interfaces.
S YNTAX
show interfaces switchport [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10)
port-channel channel-id (Range: 1-5)
D EFAULT S ETTING
Shows all interfaces.
C OMMAND M ODE
Normal Exec, Privileged Exec
C OMMAND U SAGE
If no interface is specified, information on all interfaces is displayed.
E XAMPLE
This example shows the configuration setting for port 1.
Console#show interfaces switchport ethernet 1/1
Information of Eth 1/1
Broadcast Threshold : Enabled, 500 packets/second
Multicast Threshold : Disabled
Unknown Unicast Threshold : Disabled
LACP Status : Disabled
Ingress Rate Limit : Disabled, 1000M bits per second