Microsens MS453490M Management Guide - Manual (Page 499)

C HAPTER 21 | System Management Commands
Banner Information
– 499 –
E XAMPLE
Console(config)#banner configure equipment-info manufacturer-id MS453490M
floor 3 row 10 rack 15 shelf-rack 12 manufacturer Microsens
Console(config)#
banner configure
equipment-location
This command is used to configure the equipment location information
displayed in the banner. Use the no form to restore the default setting.
S YNTAX
banner configure equipment-location location
no banner configure equipment-location
location - The address location of the device.
(Maximum length: 32 characters)
D EFAULT S ETTING
None
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
Input strings cannot contain spaces. The banner configure equipment-
location command interprets spaces as data input boundaries. The use of
underscores ( _ ) or other unobtrusive non-letter characters is suggested
for situations where white space is necessary for clarity.
E XAMPLE
Console(config)#banner configure equipment-location
710_Network_Path,_Indianapolis
Console(config)#
banner configure ip-
lan
This command is used to configure the device IP address and subnet mask
information displayed in the banner. Use the no form to restore the default
setting.
S YNTAX
banner configure ip-lan ip-mask
no banner configure ip-lan
ip-mask - The IP address and subnet mask of the device.
(Maximum length: 32 characters)
D EFAULT S ETTING
None