Microsens MS453490M Management Guide - Manual (Page 748)

C HAPTER 31 | Automatic Traffic Control Commands
– 748 –
E XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc broadcast-alarm-clear
Console(config-if)#
R ELATED C OMMANDS
auto-traffic-control action (744)
auto-traffic-control alarm-clear-threshold (745)
snmp-server enable
port-traps atc
broadcast-alarm-fire
This command sends a trap when broadcast traffic exceeds the upper
threshold for automatic storm control. Use the no form to disable this trap.
S YNTAX
[no] snmp-server enable port-traps atc broadcast-alarm-fire
D EFAULT S ETTING
Disabled
C OMMAND M ODE
Interface Configuration (Ethernet)
E XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc broadcast-alarm-fire
Console(config-if)#
R ELATED C OMMANDS
auto-traffic-control alarm-fire-threshold (746)
snmp-server enable
port-traps atc
broadcast-control-
apply
This command sends a trap when broadcast traffic exceeds the upper
threshold for automatic storm control and the apply timer expires. Use the
no form to disable this trap.
S YNTAX
[no] snmp-server enable port-traps atc broadcast-control-apply
D EFAULT S ETTING
Disabled
C OMMAND M ODE
Interface Configuration (Ethernet)