Logging host, Logging on – Microsens MS453490M Management Guide User Manual
Page 532
C
HAPTER
21
| System Management Commands
Event Logging
– 532 –
logging host
This command adds a syslog server host IP address that will receive
logging messages. Use the no form to remove a syslog server host.
S
YNTAX
[no] logging host host-ip-address
host-ip-address - The IP address of a syslog server.
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
◆
Use this command more than once to build up a list of host IP
addresses.
◆
The maximum number of host IP addresses allowed is five.
E
XAMPLE
Console(config)#logging host 10.1.0.3
Console(config)#
logging on
This command controls logging of error messages, sending debug or error
messages to a logging process. The no form disables the logging process.
S
YNTAX
[no] logging on
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
The logging process controls error messages saved to switch memory or
sent to remote syslog servers. You can use the
command to
control the type of error messages that are stored in memory. You can use
the
command to control the type of error messages that are
sent to specified syslog servers.
E
XAMPLE
Console(config)#logging on
Console(config)#